Power Generation Cycles

Browse by subtopic: Overview Internal Combustion Engine Cycles and PerformanceGas Turbine and Advanced Power Cycles

Actual Irreversible Factors in Steam Power Cycles and Efficiency Corrections

Analysis of thermal efficiency in reheat cycles and optimization effects

Basic Composition and Process of the Rankine Cycle

Brayton cycle components (constant pressure heating gas turbine cycle)

Combined Cycle Power Generation System

Construction approach for a recuperative cycle (utilizing waste heat to heat the feedwater)

Diesel Cycle Composition Process (Constant Pressure Heating Cycle)

Direction of Cycle Optimization in Modern Steam Power Plants

Drawing T-s Diagrams for the Rankine Cycle and Thermal Efficiency Calculation

Effect of Compression Ratio on Otto Cycle Thermal Efficiency

Factors Affecting the Thermal Efficiency of the Rankine Cycle (Steam Parameters, Back Pressure)

Features of a gas dynamics cycle (with gas as the working substance and work done by volume change)

Gas Dynamic Cycle's Actual Irreversible Factors and Efficiency Correction

Introduction to Modern Supercritical Power Generation Cycles

Loss Analysis in Practical Steam Power Systems

Methods to Improve the Efficiency of the Rankine Cycle: Increasing the Initial Pressure

Methods to Improve the Efficiency of the Rankine Cycle: Increasing the Initial Temperature

Optimization Approach and Efficiency Enhancement for Brayton Cycle with Heat Recovery

Otto cycle and Diesel cycle's applicable engine types comparison

Otto cycle components (constant volume heating cycle)

Otto Cycle's p-v Diagram, T-s Diagram, and Thermal Efficiency Calculation

Principles and Efficiency Improvement of Reheat Cycle

Rankine cycle processes (constant pressure heating, isentropic expansion, constant pressure heat rejection, isentropic compression)

Rankine Cycle (Steam Turbine)

Regenerative cycle's thermal efficiency calculation and economic efficiency improvement

T-SP-V

The core purpose of the steam power cycle (conversion of heat energy into mechanical energy)

The Design Concept for the Reheat Cycle (Solving the Wet Steam Problem)

Thermal Efficiency Calculation of the Brayton Cycle and Its Influence on Compressor Pressure Ratio

Thermal efficiency calculation of the Diesel cycle and the influence of compression ratio and pre-expansion ratio

Working Principle of the Regenerative Cycle (Heat Recovery Cycle)
Internal Combustion Engine Cycles and PerformanceGas Turbine and Advanced Power Cycles
Engineering Thermodynamics
Entropy Increase Principle and Exergy AnalysisThermodynamic Systems and State ParametersRadiation and Convection Composite Heat Transfer AnalysisParameters and Energy Calculations of Basic Thermodynamic ProcessesEngineering Thermodynamics Fundamentals and System ConceptsThermal System Energy Saving and Waste Heat RecoveryRefrigeration & Heat Pump CyclesGas Mixtures & Moist AirThermodynamic Basics & PropertiesPure Substance Properties & ChartsSecond Law, Entropy & ReversibilityFirst Law of Thermodynamics and Closed System Energy AnalysisCarnot Cycle & Efficiency LimitsAdvanced, Interdisciplinary & Special AppsOpen System Steady-Flow Energy EquationExergy Analysis & OptimizationThermal Equipment & Energy ConversionHeat Transfer Equipment and System OptimizationAdvanced Thermodynamics and Special Engineering ApplicationsChemical and New Energy Device ThermodynamicsSecond Law of Thermodynamics and Carnot TheoremPerformance and Efficiency of Typical Thermal EquipmentPure Substance Thermal Properties and Ideal Gas States