Power Generation Cycles

Browse by subtopic: Overview Internal Combustion Engine Cycles and PerformanceGas Turbine and Advanced Power Cycles

The core purpose of the steam power cycle (conversion of heat energy into mechanical energy)

Rankine cycle processes (constant pressure heating, isentropic expansion, constant pressure heat rejection, isentropic compression)

Drawing T-s Diagrams for the Rankine Cycle and Thermal Efficiency Calculation

Factors Affecting the Thermal Efficiency of the Rankine Cycle (Steam Parameters, Back Pressure)

The Design Concept for the Reheat Cycle (Solving the Wet Steam Problem)

Analysis of thermal efficiency in reheat cycles and optimization effects

Construction approach for a recuperative cycle (utilizing waste heat to heat the feedwater)

Regenerative cycle's thermal efficiency calculation and economic efficiency improvement

Actual Irreversible Factors in Steam Power Cycles and Efficiency Corrections

Direction of Cycle Optimization in Modern Steam Power Plants

Features of a gas dynamics cycle (with gas as the working substance and work done by volume change)

Otto cycle components (constant volume heating cycle)

Otto Cycle's p-v Diagram, T-s Diagram, and Thermal Efficiency Calculation

Effect of Compression Ratio on Otto Cycle Thermal Efficiency

Diesel Cycle Composition Process (Constant Pressure Heating Cycle)

Thermal efficiency calculation of the Diesel cycle and the influence of compression ratio and pre-expansion ratio

Otto cycle and Diesel cycle's applicable engine types comparison

Brayton cycle components (constant pressure heating gas turbine cycle)

Thermal Efficiency Calculation of the Brayton Cycle and Its Influence on Compressor Pressure Ratio

Optimization Approach and Efficiency Enhancement for Brayton Cycle with Heat Recovery

Gas Dynamic Cycle's Actual Irreversible Factors and Efficiency Correction

Rankine Cycle (Steam Turbine)

Combined Cycle Power Generation System

T-SP-V

Basic Composition and Process of the Rankine Cycle

Principles and Efficiency Improvement of Reheat Cycle

Methods to Improve the Efficiency of the Rankine Cycle: Increasing the Initial Temperature

Loss Analysis in Practical Steam Power Systems

Methods to Improve the Efficiency of the Rankine Cycle: Increasing the Initial Pressure

Working Principle of the Regenerative Cycle (Heat Recovery Cycle)

Introduction to Modern Supercritical Power Generation Cycles
Internal Combustion Engine Cycles and PerformanceGas Turbine and Advanced Power Cycles
Engineering Thermodynamics
Engineering Thermodynamics Fundamentals and System ConceptsThermodynamic Systems and State ParametersHeat Transfer Equipment and System OptimizationAdvanced Thermodynamics and Special Engineering ApplicationsRefrigeration & Heat Pump CyclesChemical and New Energy Device ThermodynamicsEntropy Increase Principle and Exergy AnalysisGas Mixtures & Moist AirSecond Law of Thermodynamics and Carnot TheoremThermodynamic Basics & PropertiesFirst Law of Thermodynamics and Closed System Energy AnalysisPure Substance Properties & ChartsPerformance and Efficiency of Typical Thermal EquipmentSecond Law, Entropy & ReversibilityRadiation and Convection Composite Heat Transfer AnalysisThermal System Energy Saving and Waste Heat RecoveryCarnot Cycle & Efficiency LimitsAdvanced, Interdisciplinary & Special AppsOpen System Steady-Flow Energy EquationPure Substance Thermal Properties and Ideal Gas StatesParameters and Energy Calculations of Basic Thermodynamic ProcessesExergy Analysis & OptimizationThermal Equipment & Energy Conversion